There are currently no product reviews.
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Exactly as described, the full user-manual (145 pages). Perfect.
Connect AC power
Connect the DC cable with the docking cradle and Pipe speaker first, then connect it with the AC adapter, and then connect the adapter with the AC power cord.Then plug the AC plug into a standard AC outlet.
Change the docking cradle to match with your portable player
The docking cradle can support both iPod and GoGear. Follow steps below to change it into desired mode - Default position is prepared for iPod - Go to B2 Install for iPod user.
Install dock adaptor
Insert a dock adapter that matches with your portable player (take iPod adapter as example).
You can use the controls on your iPod/GoGear to playing music. However, with the supplied remote control,you can enjoy music in a more easy and comfortable way. Power on/off
Press Power to turn the iPod on or off Note: This function isn't applicable for GoGear
Docking cradle Pipe speakers
Press 2; to start playing â¢ While playing, press 2; to stop playing temporarily. Press 2; again to resume playing.
AC power cord AC adapter DC cable
Pipe speakers power on/off
Install portable player
Press Volume -/+ to increase or reduce volume
Plug your portable player into the cradle (take iPod as example). -Turn on the power of pipe speakers.
This product is powered by a specified power supply unit SA1460-240200 (I/P: AC 100-240 V~, 50/60 Hz, 1.5 A; O/P: DC 24V , 2.0 A).
Skip to the previous or next track
â¢ Press â¢ Press to skip to the previous track to skip to the next track
Connect audio cable
Plug one end of the audio cable to the black 3.5mm Audio Out jack, and the other end to the audio in jack on the pipe speaker.
Searching for desired track
1. Press MENU button â¢ The MENU screen is shown on the iPod 2. Press 3 or 4 to select desired folder, then press Select (OK) button to confirm the selection Note: This function isn't applicable for GoGear
1. Slide the front cover horizontally in the direction shown above to open the front cover
To connect with a different iPod portable players, dismount the iPod first, then pop up the corresponding dock adapter and replace with a new one of the matching type.
2. Rotate the front cover in 180 degree 3. Slide the front cover back onto the docking cradle
Charging iPod using the docking station
When the iPod is properly connected on the docking cradle and the power supply to the docking cradle is connected, battery charging start automatically. Helpful hint: â¢ You can also use a USB cable (not supplied) to connect the docking cradle with your PC to charge your iPod or GoGear