There are currently no product reviews.
This manual is immaculate in it's accuracy. Everything is written very clearly and easy to understand. Written by a professional who wants to convey a clear and easy to understand message!!
This Manual (as downloaded) is both informative and comprehensive and has proved to be extremely useful. thoroughly recommended.
everything is ok, thank you very much! Product is good, no problems with download!
Great site, I always find all the manuals I need and i can't find anywhere else. PDF for the Sony PCM 3348 is complete and scan is good quality. Thank you!
It was a complete manual as stated. Very good source for older product manuals. Thanks
Turning on Your VCR 11
q Before turning on your VCR, make sure there are batteries in
the remote control and the VCR and TV are connected (see pages five-10). q You can not set up channels if you are using a Cable Box/DBS. q The instructions on this page only work when you turn on the VCR for the first time. If there is a power failure or if the VCR is unplugged for more than one minute, you may need to repeat the instructions on this page.
Turn on the TV.
Press the POWER button. The POWER light and the VCR/TV light will appear.
1 4 7
2 5 8
3 6 9
SEARCH TIME INDEX
Turn on the TV. Set it to the same channel as the CH3/CH4 switch on the back of the VCR. The menu shown below will appear.
LANGUAGE SELECT B ENGLISH ESPAÃ‘OL [ON]
RESET / PLAY
3 4 5
Press the PLAY button or the STOP button to select ENGLISH or ESPAÃ‘OL. [ON] will appear beside your choice.
Press the F.FWD button or the MENU button. AUTO SET UP will appear on the screen.
â€¢ If you do not see any on-screen displays when you turn on the VCR, check your hookups, then try again. If you still do not see any on-screen displays, follow the steps under â€śAutomatic Channel Setupâ€ť on page 12 and â€śLanguage Selectionâ€ť on page 16. â€¢ If you try to set up channels when there is no antenna or cable connected to the VCR, programming will appear to take place. Eventually, AUTO SET UP will appear on the screen steadily, and channel programming will stop. Connect an antenna or cable to the ANT(enna) IN jack of the VCR, then press the MENU button, the F.FWD button, or the REWIND button again. Channel programming will begin again.
AUTO SET UP
Press the MENU button, the F.FWD button, or the REWIND button to begin automatic channel setup. AUTO SET UP will flash on the screen. When channels are set up, the TV will go to the lowest channel available. The VCR will memorize all available channels, so when you use the CHANNEL o/p buttons, youâ€™ll only scan through channels that you receive.