Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 6 (click to view)
R
23 STOP 7 button
Stops the tape.
29 Jog dial
Advances or reverses the picture frame by frame in the still picture mode. (vP.23)
24 TV CH +/� button
Changes the TV channels. Release at a desired channel.
25 DISPLAY button
Switches display between present time, tape remaining time, time counter and channel position. (vP.22)
26 TIMER button
Displays the Timer Recording menu. (vP.29, P.30)
27 OK button
Changes the selection when using the menus.
28 RECORD ¶ button
� Starts recording when pressed once. (vP.22) � Starts a recording for 30 minutes to 6 hours long. When pressed more than once, the shut-off time increases in 30-minute intervals. (vP.26)
Note: The following buttons will light for 10 seconds when you press one of them. � PROG. +/5 � PROG. �/� � � � TV VOL (ume) +/� � TV CH (annel) +/�
w2/2 ¢/3
To insert the batteries:
1
Remove the battery compartment lid from the bottom of the remote control.
CAUTION On Battery Replacement Do not mix old and new batteries. (Also never mix alkaline batteries with manganese batteries.)
2
Install two AA batteries � R6(SUM-3)/AA � matching polarity indicated inside the battery compartment.
Note: This remote control and batteries are supplied accessories. Check to make sure they are included. Also, check �Specifications� to see what other accessories are included.