There are currently no product reviews.
Super nice! Good to have a manual in digital format.
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Turning on Your VCR 11
q Before turning on your VCR, make sure there are batteries in
the remote control and the VCR and TV are connected (see pages five-10). q You can not set up channels if you are using a Cable Box/DBS. q The instructions on this page only work when you turn on the VCR for the first time. If there is a power failure or if the VCR is unplugged for more than one minute, you may need to repeat the instructions on this page.
Turn on the TV.
Press the POWER button. The POWER light and the VCR/TV light will appear.
1 4 7
2 5 8 0
3 6 9 +100
AUTO CLOCK/ REPEAT COUNTER CHANNEL
Turn on the TV. Set it to the same channel as the CH3/CH4 switch on the back of the VCR. The menu shown below will appear.
â†’ ENGLISH ESPAÃ‘OL LANGUAGE SELECT
RESET / PLAY
Press the PLAY button or the STOP button to select ENGLISH or ESPAÃ‘OL. [ON] will appear beside your choice.
Press the F.FWD button or the MENU button. TUNER SET UP will appear on the screen.
â€¢ If you do not see any on-screen displays when you turn on the VCR, check your hookups, then try again. If you still do not see any on-screen displays, follow the steps under â€śAutomatic Channel Setupâ€ť on page 12 and â€śLanguage Selectionâ€ť on page 16. â€¢ If you try to set up channels when there is no antenna or cable connected to the VCR, programming will appear to take place. Eventually, TUNER SET UP will appear on the screen steadily, and channel programming will stop. Connect an antenna or cable to the ANT(enna) IN jack of the VCR, then press the MENU button, the F.FWD button, or the REWIND button again. Channel programming will begin again.
TUNER SET UP
Press the MENU button, the F.FWD button, or the REWIND button to begin automatic channel setup. TUNER SET UP will flash on the screen. When channels are set up, the TV will go to the lowest channel available. The VCR will memorize all available channels, so when you use the CHANNEL o/p buttons, youâ€™ll only scan through channels that you receive.