Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 12 (click to view)
XP SBC SC 490 14-02-2003 16:43 Pagina 12
12
ENGLISH
Switching on the units
POWER
1 Make sure the Parent Unit is connected to the TV and the Camera Unit is connected to the Baby Unit.The Parent Unit should be placed in its docking base. 2 Switch on the Baby Unit by pressing POWER (1). > The SYSTEM check light (3) lights green.
SYSTEM
SYSTEM
ON VOLUME OFF ON VOLUME OFF
3 Switch on the Parent Unit by turning the ON VOLUME OFF control (16) to ON. Observe the clicking sound. > The SYSTEM check light (15) lights green. 4 Switch on your TV and select the External Input (·). Note:The Parent Unit must remain in the docking base otherwise the signal from the Baby Unit is interrupted. In this case you will receive no picture on the TV screen.
Adjusting loudspeaker volume of the Parent Unit
� Adjust the volume level of the Parent Unit to the preferred level using the ON VOLUME OFF control (16).
Checking that the units have contact
� Check that the SYSTEM check light (15) on the Parent Unit lights continuously green to confirm that both units have contact. > The SYSTEM check light (15) lights/flashes red and the system check alarm on the Parent Unit beeps when: - the units are not in touch; - out of range; - there is interference.