Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Text excerpt from page 3 (click to view)
HOOKING UP YOUR TV (ANTENNA/CABLE CONNECTIONS) (CONTâD)
Connect your Antenna or Cable signal to the IN FROM ANT(enna) jack on the VCR. Connect a coaxial cable to the OUT TO TV jack on the VCR and to the ANT(enna) IN jack on the TV. The coaxial cable may be supplied with the VCR. Refer to the VCR owner's manual for other possible connections and for operating details.
he basic Antenna/Cable to
VCR to TV connection is
shown here. If you have a Cable Box, refer to the VCR ownerâs manual for details.
300 to 75â¦ Adaptor Outdoor VHF/UHF Antenna
IN FROM ANT. OUT TO TV
Cable TV signal
Back of TV
If you do not have a Cable Box, then you're ready to connect your Cable TV signal to the TV. If you have a Cable Box: Connect the Cable TV signal to the IN jack on the Cable Box. Connect the Cable TV signal to the ANT(enna) IN jack on the TV. If you have a Cable Box: Use a coaxial cable to connect the OUT jack of the Cable Box to the ANT(enna) IN jack on the TV. NOTE: The coaxial cable might be supplied by the Cable TV company.
To select only the channels on your Cable system, see First Time Setup (page 4). If you use a Cable Box, set the TV to the same channel as the CH 3/4 switch on the back of the Cable Box and select channels at the Cable Box.
our Cable TV signal may be a single (75 ) cable or a Cable Box installation. In either case, the connection to the TV is very easy.
Note to the Cable TV System Installer: This reminder is provided to call the Cable TV system installerâs attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding - in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible.