|
Who's Online
There currently are 5903 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
3-1
3-1
DISASSEMBLY INSTRUCTIONS
Dismantling of the Front Panel Assembly
1) Open the DVD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the Tray Cover. 2) Return the set to its upright position and remove the Tray Cover as shown in Figure 3 and close the tray manually by pushing it back in. 3) Loosen 9 screws and remove the Top Cover by lifting the rear portion upwards before sliding it out towards the rear. - 5 screws on the back - 2 screws each on the left & right side 4) Loosen 7 screws & lift up the top edge of Front Panel assembly to free some catches before sliding it out towards the front. - 4 screws on the bottom - 1 screw "C" on the inside as indicated in Figure 5. - 1 screw each on the left & right side
2mm
Dismantling of the Main Board 1) Loosen 5 screws "B" on the top of main board as shown in figure5.
2) Loosen 9 screws "D" at the back panel as shown in figure 6. 3) Remove all connectors on the RGBScart and main board.
Note: If this is not possible, the DVD Tray has to be open manually.
Take a mini screw driver about 2mm diameter and make a marking 24mm from the tip as shown in figure 2. place the set on its side, insert the mini screw driver till the marking and slide it towards the right as shown in figure 1 until the Tray moves out of the Front Panel.
B
RGB Jack use for MX3600/37 ; MX3700/37S Scart Jack use for MX3800/22S only
C
Repeat
Figure 5
D
Figure 1
Marking just outside the slot on the rear cabinet.
Figure 6
Dismantling of the Servo Board
1) Loosen 4 screws "A" to remove the Servo Board from the DVD Module as shown in figure 4
Dismantling of the Tuner Board 1) Loosen 4 screws "E" on the bottom cover as shown in figure 7.
3) Loosen 4 screws "F" at the top of the Power Board as shown in figure 8
24mm
Figure 2
A
F
E
Figure 3
Note: Do not lost the limited parts of the Servo board
Figure 4
Figure 7
Figure 8
|
|
|
> |
|