perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Text excerpt from page 18 (click to view)
Getting Started
Step 1: Inserting batteries into the remote control
3 1 2
Step 2:
Setting the clock
E n g l i s h
The clock can be set in either 12-hour or 24-hour mode ("12:00 AM" or "00:00" for example).
buttons on front panel
CLOCK�TIMER
DVD system�s display panel
2
SELECT CLOCK OR
CLOCK�TIMER
1 2 3
Open the battery compartment. Insert two batteries type R06 or AA, following the indications (+-) inside the compartment. Close the cover.
3 4 5 6
CLOCK
SEARCH
01:38 PM
PROG
13:38 13:38
Using the remote control to operate the system
CLOCK�TIMER
1 2
Aim the remote control directly at the remote sensor (iR) on the front panel. Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TV/AV, TUNER.) Then select the desired function (for example ��, S, T).
OPEN�CLOSE DISC 1 DISC 3 DISC 2 DISC 4 DISC 5
DISC 1
DISC 2
DISC 3
1 2
Press STANDBY ON to switch on the DVD system. Press and hold CLOCK�TIMER until "SELECT CLOCK OR TIMER" appears. Press T (if necessary) to change the display to "CLOCK,", then press CLOCK�TIMER again to confirm. Press S / T to set the minutes and hours. To increase the speed, hold down S or T. � The changes in minutes will roll over to the hours.
STANDBY-ON
iR SENSOR
3
TV/AV DISC/ MEDIA TUNER AUX/DI
3
1 4 7
SURR.
2 5 8 0
VOL
3 6 9
SOUND
4
SYSTEM MENU
DISC MENU
SEATING
ZOOM
PREV
NEXT
5 6
OK
STOP PLAY/PAUSE
Press PROG to change between 12-hour and 24-hour clock mode. Press CLOCK�TIMER again to store the setting. � The clock will start working.
DISC SKIP REPEAT
REPEAT PROGRAM
CAUTION!
� Remove batteries if they are exhausted or if the remote is not to be used for a long time. � Do not use old and new or different types of batteries in combination. � Batteries contain chemical substances, so they should be disposed of properly.
To view the clock time in any active mode
G Press CLOCK�TIMER. � The clock will display for a few seconds. Notes: � If the DVD system is disconnected from the power supply, it will erase the clock setting. � If you do not press any buttons within 90 seconds, the system will exit clock setting mode.
18
pg 001-044_MX39-37-Eng1 18 2/25/03, 10:28 AM 3139
