The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Text excerpt from page 12 (click to view)
12 Hookups - TV (cont�d)
Connecting to a TV with an S-Video In jack
S-Video Cable
Red & White Audio Cable
Back of TV (example only)
1
Pr/Cr
Pb/Cb
3
2
;
Rear of DVD Receiver
3
1 2 3 4 5 6
Connect the DVD Receiver�s S-VIDEO OUT jack to the S-VIDEO IN jack on your TV. You will need an S-Video cable (not supplied). To hear TV channels through the DVD Home Cinema System, connect the supplied red and white audio cables to the DVD Receiver�s red/white, right/left AUDIO IN jacks and to the TV�S right/left AUDIO OUT jacks. Match the cable colors to the jack colors. Connect the power cords of the DVD Receiver and TV to a power outlet. Turn on the TV and set it to the correct S-Video In channel. Go to the lowest TV channel and change channels down until you find the S-Video In channel. (It is not channel 3 or 4 as it might be when using a VCR.) See your TV owner�s manual for details. Press STANDBY-ON y on the front of the DVD Receiver to turn on the DVD Receiver. The red Standby light will disappear. It is not necessary to set VIDEO OUT to S-VIDEO. S-VIDEO is the DVD Receiver�s default setting. However, if your picture is distorted, check the VIDEO OUT setting. Make sure it is set to S-VIDEO. Details are on page 29.