There are currently no product reviews.
This is a good quality scan of the Operation & Maintenance (Service) Manual for the PAL version of this high-band broadcast umatic, BVU-800P
All schematics and lineup procedures appear to be included in this one manual AFAICT.
The file size is just over 113 MB which gives an idea of the quality and number of pages.
All of the schematics, which contain some fairly small print, are easily readable when you zoom into the page.
John Thompson, Newcastle Upon Tyne, England.
Good quality, all schematics of few of models. There is also short form of user manual and regulation manual.
Perfect copy of the service manual. you can enlarge every page, and it comes up
with all details.
It´s very very nice manual with all, what i need. Original in good quality. Very fast business. Very much thanks...
Purchased the manual that I was looking for at a great price and could download it easily.. Great service experience and for future purchases I plan to use the site.
Thank you very much
Dismantling of the Front Panel Assembly
1) Open the DVD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the Tray Cover. 2) Return the set to its upright position and remove the Tray Cover as shown in Figure 3 and close the tray manually by pushing it back in. 3) Loosen 9 screws and remove the Top Cover by lifting the rear portion upwards before sliding it out towards the rear. - 5 screws on the back - 2 screws each on the left & right side 4) Loosen 7 screws & lift up the top edge of Front Panel assembly to free some catches before sliding it out towards the front. - 4 screws on the bottom - 1 screw "C" on the inside as indicated in Figure 5. - 1 screw each on the left & right side
Dismantling of the Main Board 1) Loosen 5 screws "B" on the top of main board as shown in figure5.
2) Loosen 9 screws "D" at the back panel as shown in figure 6. 3) Remove all connectors on the RGBScart and main board.
Note: If this is not possible, the DVD Tray has to be open manually.
Take a mini screw driver about 2mm diameter and make a marking 24mm from the tip as shown in figure 2. place the set on its side, insert the mini screw driver till the marking and slide it towards the right as shown in figure 1 until the Tray moves out of the Front Panel.
RGB Jack use for MX3600/37 ; MX3700/37S Scart Jack use for MX3800/22S only
Marking just outside the slot on the rear cabinet.
Dismantling of the Servo Board
1) Loosen 4 screws "A" to remove the Servo Board from the DVD Module as shown in figure 4
Dismantling of the Tuner Board 1) Loosen 4 screws "E" on the bottom cover as shown in figure 7.
3) Loosen 4 screws "F" at the top of the Power Board as shown in figure 8
Note: Do not lost the limited parts of the Servo board