Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
Text excerpt from page 11 (click to view)
To exit without storing the Plug and Play
MICRO SYSTEM MCM204
â Press 9 on the system. â If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again. Notes: â If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed. â During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode.
IMPORTANT: Before you operate the system, complete the preparation procedures.
Plug and Play (for tuner installlation)
Plug and Play allows you to store all available radio stations automatically. First time setup/power up
When you turn on the main supply, "AUTO INSTALL - PRESS PLAY" is displayed. Press ÃÃ on the system to start installation. â "PLUG AND PLAY" .... "INSTALL" is displayed, followed by "TUNER" and "AUTO". â PROG starts flashing. â The system will automatically store the radio stations with sufficient signal strength, starting from FM, and followed by MW band. â When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station will be played. To reinstall Plug and Play
In standby mode, press and holdÃÃ on the system until "AUTO INSTALL - PRESS PLAY" is displayed. Press ÃÃ again to start installation. â All previously stored radio stations will be replaced.