Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 21 (click to view)
RADIO RECEPTION Radio reception is poor. â If the signal is too weak, adjust the antenna or connect an external antenna for better reception. â Increase the distance between the Micro HiFi System and your TV or VCR.
TAPE OPERATION / RECORDING Recording or playback cannot be made. âCHECK TAPEâ is displayed. The tape deck door cannot open.
â Clean deck parts, see âMaintenanceâ. â Use only normal (IEC I) tape for recording. â Apply a piece of adhesive tape over the missing tab space. â Remove and reconnect the AC power plug and switch on the system again.
GENERAL The system does not react when buttons are pressed. Sound cannot be heard or is of poor quality.
The left and right sound outputs are reversed. The remote control does not function properly.
â Remove and reconnect the AC power plug and switch on the system again. â Adjust the volume. â Disconnect the headphones. â Check that the speakers are connected correctly. â Check if the stripped speaker wire is clamped. â Check the speaker connections and location. â Select the source (CD or TUNER, for example) before pressing the function button ( , , ). â Reduce the distance between the remote control and the system. â Insert the battery with its polarities (+/â signs) aligned as indicated. â Replace the battery. â Point the remote control directly toward IR sensor on the front of the system. â Set the clock correctly. â Press TIMER ON / OFF to switch on the timer. â If a recording is in progress, stop the recording. â Power has been interrupted or the power cord has been disconnected. Reset the clock/timer.