I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 21 (click to view)
RADIO RECEPTION Radio reception is poor. â If the signal is too weak, adjust the antenna or connect an external antenna for better reception. â Increase the distance between the Micro HiFi System and your TV or VCR.
TAPE OPERATION / RECORDING Recording or playback cannot be made. âCHECK TAPEâ is displayed. The tape deck door cannot open.
â Clean deck parts, see âMaintenanceâ. â Use only normal (IEC I) tape for recording. â Apply a piece of adhesive tape over the missing tab space. â Remove and reconnect the AC power plug and switch on the system again.
GENERAL The system does not react when buttons are pressed. Sound cannot be heard or is of poor quality.
The left and right sound outputs are reversed. The remote control does not function properly.
â Remove and reconnect the AC power plug and switch on the system again. â Adjust the volume. â Disconnect the headphones. â Check that the speakers are connected correctly. â Check if the stripped speaker wire is clamped. â Check the speaker connections and location. â Select the source (CD or TUNER, for example) before pressing the function button ( , , ). â Reduce the distance between the remote control and the system. â Insert the battery with its polarities (+/â signs) aligned as indicated. â Replace the battery. â Point the remote control directly toward IR sensor on the front of the system. â Set the clock correctly. â Press TIMER ON / OFF to switch on the timer. â If a recording is in progress, stop the recording. â Power has been interrupted or the power cord has been disconnected. Reset the clock/timer.