Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
helpful manual.good service.Quick response.will use again
Text excerpt from page 7 (click to view)
4.4 Monitor Output The monitor output is designed to �look� into a 75 ohm load. Therefore, if you loop the monitor output line through monitors or other equipment, be sure their terminations are set to Hi-Z. Only the last unit on the line should have its termination set to 75 ohms.
5
OPERATION
5.1 RUN Button and Indicator Momentary depression of the RUN button initiates automatic sequencing known as the �run mode�. The green LED above this button will indicate the switcher is in the run mode.
5.2 DWELL Control This control is located on the rear panel. This adjustment controls the rate at which the cameras are sequenced during the run mode. Rotating the control clockwise slows the rate of sequencing (increases the dwell time). Rotating the control counter-clockwise causes the switcher to sequence faster (decreases the dwell time). The dwell time is approximately 2 seconds when the control is turned fully counter-clockwise; full clockwise rotation of the control provides a dwell time of approximately 45 seconds. 5.3 Camera Buttons and Indicators These buttons are used to call-up a camera and stop automatic sequencing. When a camera button is pressed, that camera will be called-up to the monitor screen, the camera LED indicator will light, and the RUN LED indicator will go out.
