|
|
|
Who's Online
There currently are 5744 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
6. Maintenance
Cleaning Caution
AV Mute Source Menu OK
>
Switch off and disconnect the projector before cleaning. 1 Press the Standby button twice to switch off the projector. � The Standby indicator starts blinking orange. 2 Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in Standby) and disconnect the mains lead and all other cables. Cleaning the cabinet � When the cabinet is dusty, clean it by gently wiping with a soft cloth. � A chamois leather slightly moistened with water is sufficient for cleaning the housing. � Do not use cleaning agents as they may harm the housing. Cleaning the lens � When the lens is dirty or dusty, first blow the dust off and then gently wipe with a soft brush or lens cleaning paper. Never touch the lens with your fingers. � The lens is likely to become mouldy if left dirty. Cleaning the dust filter Make sure to clean the dust filter regularly. 1 Switch off the projector and wait until the cooling fan has stopped before disconnecting the 2 3 projector. Turn the projector over. Never place the projector on the side where the connections are located! Press tab A and remove filter holder B from the projector.
Lamp Stand by Temp
Important
A B
4 5 6 7
Press clamp C, open the holder and remove the filter. While firmly holding the filter, gently remove any accumulated dust, from the dusty side, with a vacuum cleaner. Press clamp C, put the filter back in place and release clamp C. Firmly press the filter edges in place. Close the filter holder.
C
A B
C
8
Press tab A and insert the filter B into the projector.
Notes
We advise you to clean the filter every 100 hours. Operating the projector without filter or with a torn or damaged filter may seriously damage the projector. When the filter is damaged replace it with a filter of the same type (12 nc: 3122 434 0157 0). The projector power cannot be switched on again unless the filter holder is installed correctly.
Philips Home Cinema Projector
English User guide Garbo
27
|
|
|
> |
|
