I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
thanks for this download i got a pioneer bdp-lx70a blu-ray player and it had no manual i search everywhere on the internet and came across owner-manuals.com and i found that it was so easy to find and downloaded from this site if i ever need a manual again this would be the first place that i would come too thanks guys
Text excerpt from page 9 (click to view)
6. SET UP
INSERTING THE BATTERIES IN THE REMOTE CONTROL Horizontal angle (horizon) � Adjust or correct a possible oblique displayed picture by turning the horizontal adjusters to the desired position.
Push
On/Off f
Standby Lamp Mute RC RC
Data ta
Video
AVMute
Menu
OK
Volume
Video
S-Video in Video in L Audio R
Data
Mouse Data in in
Audio
Power
out Audio in
1. Push and slide the lid in the direction of the arrow. 2. Install three �AA� batteries as indicated inside the battery compartment. 3. Replace the lid and snap into place. Caution: Do not mix old and new batteries (also never mix alkaline and manganese batteries).
Note: The maximum range of the remote control is 20 m (± 65 feet).
Up: turn the adjuster(s) to the left. Down: turn the adjuster(s) to the right. � Use the FOCUS Ring and ZOOM Ring to readjust the focus and size of the image.
Notes: � When adjustments are not properly made, the picture may become distorted, depending on the relative positions of the projector and the screen. � If the projector and the screen are not properly placed, the picture will be distorted, producing a keystone image as shown at right. Keystoned Image
CAUTION! When all required adjustments have been made, switch off the projector before making any other connections (see �Installation�).
MOVING THE PROJECTOR
1. Press the STANDBY/ON/OFF button to switch off the projector. The standby indicator lights up red. 2. Wait until the cooling fan has stopped (about 3 minutes after the projector has been switched off) and disconnect the mains lead and all other cables. 3. Make sure the lens is turned back in to prevent damage to the lens. 4. Put the lens cap back in place to prevent dust, dirt or other contamination from harming or damaging the front of the projector lens when moving the projector.
On/Off
Standby Lamp Mute RC RC
Data ta
Video
AVMute te
Menu
OK
Volume
Video
S-Video in Video in L Audio R
Data
Mouse Data in in
Audio
Power
in Audio out
Note: Never place the projector on the side where the connections are located.
9
