PHILIPS HP4642/17
Owner's Manual

EnGlIsh
Introduction Philips TRESemmé straighteners provide ultra-fast and super-smooth straightening results. The EHD+ (Even Heat Distribution) Ceramic NanoSilver Technology provides optimal heat distribution at high temperatures for long-lasting, professional results. Important Read this user manual carefully before you use the appliance and save it for future reference. Danger Keep the appliance away from water. Do not use it near or over water contained in baths, washbasins, sinks etc. When you use the appliance in a bathroom, unplug it after use. The proximity of water presents a risk, even when the appliance is switched off. Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. Check the condition of the mains cord regularly. Do not use the appliance if the plug, the mains cord or the appliance itself is damaged. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Keep the appliance away from non-heat-resistant surfaces and never cover the appliance with anything (e.g. a towel or clothing) when it is hot. Keep the appliance away from flammable items. Caution For additional protection, we advise you to install a residual current device (RCD) in the electrical circuit that supplies the bathroom. This RCD must have a rated residual operating current not higher than 30mA. Ask your installer for advice. The straightening plates and the plastic parts near the plates reach a high temperature quickly. Prevent the hot surfaces of the appliance from coming into contact with your skin. Only use the appliance on dry or damp hair. Do not leave the plates in your hair for more than a few seconds at a time as this may cause damage to your hair. For safety reasons, the straightener automatically switches off after having been on for 1 hour. Always unplug the appliance after use. Do not wind the mains cord round the appliance. Wait until the appliance has cooled down before you store it. Keep the straightening plates clean and free of dust, dirt and styling products such as mousse, spray and gel. Dust, dirt and styling products may cause damage to the nano-silver ceramic-coated straightening plates. The plates have a nano-silver ceramic coating. This coating slowly wears away over time. This does not affect the performance of the appliance. If you use the appliance on colour-treated hair, the straightening plates may stain. The maximum temperature occurs just after heating up. The actual temperature during use may be lower. Never leave the appliance unattended when it is plugged in. Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Preparing for use Washing your hair Everybody wants shiny and beautiful hair. A good hair-washing routine can help to achieve this. 1 Wet your hair thoroughly for 30-60 seconds. 2 Pour some TRESemmé shampoo into the palm of your hand. Spread it between your hands and distribute it evenly through the hair. 3 Gently massage your hair and scalp. Do not rough up the hair or pull up long hair onto the scalp, as this may cause tangles.

4 Massage your scalp with your fingertips. This stimulates blood circulation and is gentler to the hair cuticles. 5 Rinse your hair thoroughly, as poor rinsing can result in dull hair. Finish with a cold rinse for extra shine. Note: After shampooing, use TRESemmé remoisturising conditioner to detangle the hair and improve its condition. Drying your hair To get super-smooth results, it is essential to prepare your hair for straightening. Dry your hair properly with a hairdryer to ensure a professional, smooth finish. 1 After washing, squeeze excess water out of the hair with your hands and then towel-dry the hair. Use a comb to disentangle the hair gently from the roots to the tips. 2 Divide the hair into sections using clips. Start at the back. 3 To dry each section, pull a straightening brush down the hair length. Follow the brush with the hairdryer, with its nozzle pointing towards the hair ends. 4 When you have finished drying each section, set the hairdryer to the cool setting for a final cool shot. This closes the cuticles and adds shine to the hair. Using the appliance straightening your hair Straighteners are powerful styling tools and must always be used with care. As with all straighteners that reach salon-high temperatures, do not use the appliance frequently to avoid damage to the hair. , If you use the straightener incorrectly or if you use it at the wrong temperature setting, you could overheat your hair or even burn it. Always follow the following steps: 1 Put the plug in the wall socket. 2 Turn the on/off switch. The power-on light goes on. 3 Let the appliance heat up. Never leave the appliance unattended when it is plugged in. Always put the appliance on a heat-resistant surface when it heats up and when it is hot. 4 Turn the adjustment knob to the preferred temperature setting (1 to 25) (Fig. 1). 5 Comb or brush your hair so that it is disentangled and smooth (Fig. 2). Use a comb to divide the hair into sections. Do not put too much hair in one section. Note:Tip: it is better to section off the crown area and to straighten the hair underneath first.Then straighten the top area. 6 Take a section that is not wider than 5cm. Place it between the straightening plates and press the handles of the appliance firmly together. 7 Slide the straightener down the length of the hair in 5 seconds, from root to hair end, without stopping to prevent overheating (Fig. 3). 8 Repeat this process after 20 seconds until you have achieved the desired look. 9 Let your hair cool down. Do not comb or brush it before it has cooled down, as this would ruin the hairstyle you have just created. Cleaning 1 Make sure the appliance is switched off and unplugged. 2 Let the appliance cool down completely on a heat-resistant surface. 3 Clean the appliance with a damp cloth. storage Never wind the mains cord round the appliance. 1 Make sure the appliance is switched off and unplugged. 2 Let the appliance cool down on a heat-resistant surface before you store it.
1 2 3 4

-

-

-

-