PHILIPS HD4672/80
Owner's Manual

ENGLISH

5

Using the kettle

C

1 2

Wind excess mains cord around the base of the appliance. Put the base with the kettle on a cool, flat surface, out of the reach of children and put the plug in the wall socket.

Only use the kettle in combination with its original base. 3 Take the kettle off its base. Fill the kettle with water through the spout.

C

4

Never fill the kettle while it is standing on its base.

2

1

C

� You can also open the lid to fill the kettle. Do not put less than 0.1 litre of water in the kettle. - If the kettle boils dry, it will switch off automatically but the On/Off switch will stay in the "I" position. After 10 minutes the kettle must be lifted off the base to reset its dry-boil protection, you can use the kettle again. Do not fill the kettle beyond the 'MAX' indication. - If too much water has been put in the kettle, boiling water may be ejected from the spout. 5 Close the lid and put the kettle on its base.

Make sure the lid is properly closed, otherwise the kettle will boil dry.

C

6 Set the On/Off switch to position "I". The kettle starts heating up. The appliance switches off automatically when the water has reached the boiling point. The On/Off switch returns to the "O" position. 8 You can interrupt the boiling process by setting the On/Off switch to "O". 7