|
|
|
Who's Online
There currently are 5884 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
RECORDING
tape deck 2) 1 Press TAPE ( TAPE 1�2 ) to select tape deck 2. 2 Load the prerecorded tape into tape deck 1 and a blank tape into tape deck 2. � Make sure the tape in tape deck 1 has its full spool to the left. 3 (For Tape Deck 2 only) Press SIDE on the remote control to select the recording side. 4 Press DUB (HSD) once for normal speed dubbing or twice (within 2 seconds) for high speed dubbing. � �NORMAL� (normal speed) or �FAST� (high speed) will be displayed, followed by �DUBBING�. � The HSD flag appears on the display during high speed dubbing. � Dubbing will start immediately. � The REC flag starts flashing. 5 Press�to stop dubbing. Notes: � At the end of side A, flip the tapes to side B and repeat the procedure. � Dubbing of tapes is only possible from tape deck 1 to tape deck 2. � To ensure good dubbing, use tapes of the same length. � During high speed dubbing in Tape mode, the sound is reduced to a low volume.
English
23
Dubbing tapes (from tape deck 1 to
� You can listen to another source while dubbing.
Digital Recording via Digital Out
For CD digital recording, please refer to the Instructions Manual of the CD Recorder, digital audio equipment, etc.
CD Synchro Start Recording
1 Load a blank tape into tape deck 2 and a disc into a disc tray. 2 Press CD to select CD mode. � You can program the tracks in the order you want them to be recorded (see Programming Tracks). If you do not, the tracks are recorded according to the order on the selected disc. 3 Press REC to start recording. � The REC flag starts flashing. � CD will start playback automatically. 4 Press�to stop recording.
One Touch Recording
� For One Touch Recording, as soon as you press REC, the current source (CD, TUNER or AUX) will be recorded on tape deck 2 1 Load a blank tape in tape deck 2. 2 Press REC to start recording. � The REC flag starts flashing. 3 Press�to stop recording.
Note: � When you press RECORD while in TAPE mode, "SELECT SOURCE" will be displayed. One Touch Recording is not possible in TAPE mode.
|
|
|
> |
|
