|
Who's Online
There currently are 5917 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
2-1
SERVICE HINTS
REPAIR POSITION COPPERSIDE REPAIR POSITION COMPONENTSIDE
To get access to the copperside of the printed board assembly proceed as follows: 1. Remove the two screws on the bottom 2. Open the CD-door and remove the screw on the right side of the cabinet 3. Open the battery-door and remove the screw inside the battery compartment 4. Lift the bottom (take care of battery springs) 5. Supply the unit via external DC-socket 6. Ensure that the door switch is closed during measurements
To get access to the componentside of the printed board assembly proceed as follows: 1. Remove the two screws on the bottom 2. Open the CD-door and remove the screw on the right side of the cabinet 3. Open the battery-door and remove the screw inside the battery compartment 4. Lift the cabinet part 5. Supply the unit via the external DC-socket 6. Ensure that the door switch is closed during measurements
DISMANTLING THE CD-DOOR
To dismantle the CD-door proceed as follows: 1. Dismantle the bottom as described above 2. Remove the printed board/drive assembly 2. Disconnect the membrane keyboard (flex-foil connector on copperside of printed board) 3. Bend the cabinet leftwards downwards 1, while bending the CD-door rightwards upwards 2 The procedure appears to be tricky at first, but force needs to be applied with thumb and middle finger only. It�s just like snapping one�s fingers.
Remark: Don�t worry about applied force - both parts have a solid design. However, do not use screwdrivers or tools like that. Sharp edges might damage hinge or cabinet part.
|
|
|
> |
|