|
|
|
Who's Online
There currently are 6002 guests and
3 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I purchased a copy of my old JVC VCR Service manual from Owner-Manuals.com
The copy was complete and valuable to me.
I was able to fix my VCR - it had a bad belt.
I am glad I found Owner-Manuals.com
Great Price. Thanks
;
Great service! I got manual to my sony receiver for very reasonoble price.
;
Good service, well organized. Cheap, and the service manual was as expected. A valuable service for those of us wanting to keep the old junk going!
;
The manual arrived very quickly and had all the information I needed - Very satisfied with this seller. - Thanks -
;
Good quality, the manual help me to repair the echo/reverb section
3-12
DAC_I2C, DAC_I2Cenable, DAC_I2Cdisable (for SD5.2 only) This nucleus checks the interface between the I2C controller on the ZiVa5 and the external DAC board. DAC_ClockInternal, DAC_ClockExternal (for SD5.2 only) These nuclei select the final clock input to the audio DAC. - Internal clock means the PCM clock from the monoboard is used. - External clock means the DSD clock on the AV board is used. DAC_AudioPreMuteOn, DAC_ AudioPreMuteOff (for SD5.2 only) This nucleus selects Audio Pre-mute on/off. DAC_CentreOn, DAC_ CentreOff (for SD5.2 only) This nucleus selects the centre on/off. BedReadFlashID Loads a special diagnostic firmware on the front engine which reads the Flash device and manufacturer�s ID . BedCalcRomChkSum Loads a special diagnostic firmware on the front engine that calculates the checksum of the front engine ROM. BedScratchTest Loads a special diagnostic firmware on the front engine that checks the scratch detector circuit of the front engine. DAC_Reset This nucleus resets the DAC board. DAC_ModeCDDA, DAC_ModeDVD48, DAC_ModeDVD96, DAC_ModeDSD (for SD5.2 only) - DAC_ModeCDDA switches the DACs into CDDA mode. - DAC_ModeDVD48 switches the DACs into DVD 48 kHz mode. - DAC_ModeDVD96 switches the DACs into DVD 96 kHz mode. - DAC_ModeDSD switches the DACs into DVD DSD mode. DAC_LowPowerStandbyOn, DAC_LowPowerStandbyOff (for SD5.2 only) DAC_LowPowerStandbyOn switches the Low power standby mode on, removing power supply to SCART switch IC. DAC_LowPowerStandbyOff switches the Low power standby mode off, enabling power supply to SCART switch IC. DAC_UpSamplingFreq192k, DAC_ UpSamplingFreq96k, DAC_UpSamplingOn, DAC_ UpSamplingOff (for SD5.2 only) These nuclei select whether upsampling should be activated and at what frequency. Furore_Reset (for SD5.2 only) This nucleus resets the Furore IC. Furore_High, Furore_Low (for SD5.2 only) These nucleus sets the output lines DSD_PCM0-9 to either high or low.
|
|
|
> |
|
