There are currently no product reviews.
excellent quality, contains circuits and scan quality, 110 pages
It was easy done, and I got exactly what I was looking for.
The manuel was exactly what I needed and I received it promptly. Thanks
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
Great to be able to set channels again, on an old but stoll fine working TV
Step 1: Using the Remote Control Step 2: Setting up the TV
IMPORTANT! Make sure you have completed all the necessary connections. (See page 6-7 âConnecting TVâ).
H IU M
1 Turn on the TV and set to the correct
video-in channel. You should see the DVD background screen on the TV. lowest and highest channels and may be called FRONT, A/V IN, or VIDEO. See your TV manual for more details. â Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel. â Or, the TV Remote Control may have a button or switch that chooses different video modes. â Or, set the TV to channel 3 or 4 if you are using an RF modulator.
2 Usually these channels are between the
1 Pull out the plastic protective sheet. 2 To replace battery (Lithium CR2025);
â pull out the battery compartment â replace a new battery and fully insert the battery compartment back to the original position.
3 Close the cover.
Using the Remote Control to operate the Player
3 If you are using external equipment, (eg.
1 Aim the Remote Control
directly at the remote sensor (iR) on the front panel. between the Remote Control and the DVD Player while operating the DVD Player.
audio system or receiver), turn it on and select the appropriate input source for the DVD Player output. Refer to the equipment ownerâs manual for detail.
E n g l i s h
2 Do not put any objects
To deactivate Progressive manually q When the distorted picture still appears on the TV, it may be due to the connected TV does not accept progressive signals, and progressive is set by mistake. You must reset the unit to interlace format.
CAUTION! â Remove batteries if they are exhausted or if the Remote Control is not being used for a long time. â Batteries contain chemical substances, so they should be disposed properly.
1 Turn off your TV progressive scan mode
or turn on to interlaced mode (refer to your TV user manual.)
2 Press / (OPEN/CLOSE) on the DVD
player to open the disc tray.
3 Press numeric keypad â1â on the
remote control for few seconds. â The DVD blue background screen will appear on the TV. 11
18/01/2005, 2:56 AM 3139