There are currently no product reviews.
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
Super nice! Good to have a manual in digital format.
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Setting Up your DVD/VCR, VCR Operation
Changing the Language
If you want to change the language used on the TV screen menus, follow the steps below. Press the VCR button, then the MENU button. Press the PLAY B or STOP C button to select INITIAL, then press the FF g button. Press the PLAY B or STOP C button to select LANGUAGE, then press the FF g button. Press the PLAY B or STOP C button to select your desired language. Press the MENU button.
1 2 3 4 5
If playback does not start automatically, press the VCR button, then press the PLAY B button. Press the STOP C button to stop playback and press the STOP/EJECT A button on the DVD/VCR to remove the tape. Note: â When playing a S-VHS format, you canât get the high resolution picture and noise lines may appear on the picture. IF A TAPE IS ALREADY IN THE DVD/VCR Using the buttons on the DVD/VCR Just press the PLAY B button on the DVD/VCR. Power will automatically turn on and playback will start. (Direct Button Operation) Using the buttons on the remote control Press the STANDBY-ON button to turn on, and then press the PLAY B button.
A Status Display
To check the Counter, or Clock & Channel number, press the DISPLAY button. If the display shows an abnormal reading; When power is off, press the RESET button on the bottom of the DVD/VCR with the tip of a pen etc.The DVD/VCR will reset the all setting for VCR features including timer recordings, the clock and the language settings. In this case, you need to reset these settings. FRONT SIDE
Recording a Video Cassette Tape 1
In stop mode, insert a tape with its record tab intact into the cassette compartment. a CST. IN light appears on the front of DVD/VCR.
Press the SPEED button until the desired tape speed appears briefly. Use the P +/â buttons or the numerical key pad button to select the TV channel to be recorded.
Playing a Video Cassette Tape 1 2
Turn on the TV and set the correct channels per your DVD/VCR channel. With the DVD/VCR power off, insert a tape in the cassette compartment. a Playback will start automatically, if the tapeâs record tab has been removed.
Press the REC button to start recording. G If a tape without a record tab is in the DVD/VCR, the DVD/VCR will eject the tape. 5 Press the PAUSE k button once to pause the recording temporarily.
Press the PAUSE k button again or the REC button to resume recording. To stop recording, press the STOP C button. Note: â Changing tape speed during recording will cause distortion on the tape.
G If the DVD/VCR power was already on, press the SOURCE button to switch to VCR mode.