|
Who's Online
There currently are 5840 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Product was very good. Received quickly and complete
;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Connecting the power cord
+ +
1 Plug the female end of the supplied power cord into the Mains (AC) jack 2
on the rear of the player. Connect the other end of the cord to an AC outlet. Note: When the player is in the �STANDBY� mode, it is still consuming some power. If you wish to disconnect your player completely from the power, press POWER ON/OFF Caution: Only qualified service personnel should remove the cover or attempt to service this device.
Remote control battery installation
Loading the batteries
1 Open the battery compartment cover. 2 Insert batteries as indicated inside the battery compartment. 3 Close the cover.
Caution: Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the video signal of your TV.This setting only affects the television�s on-screen display that shows the stop and setup modes.You may select either NTSC or PAL.To change the DVD player setting to PAL or NTSC, follow the steps below.
1 Press the POWER ON/OFF button on the front panel of the DVD 2 3 4
player to turn OFF the DVD player. Press and hold / and T on the front of the DVD player.While holding / and T, press POWER ON/OFF. After PAL or NTSC appears on the display panel of the DVD player, release / and T at the same time.The PAL or NTSC that appears on the display panel indicates the current setting. To change the setting, press T within three seconds.The new setting (PAL or NTSC) will appear on the display panel.
16 PREPARATION
|
|
|
> |
|