My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
The owners manual is very good. all my how to questions were answered in detail.
Text excerpt from page 16 (click to view)
Connecting the power cord
+ +
1 Plug the female end of the supplied power cord into the Mains (AC) jack 2
on the rear of the player. Connect the other end of the cord to an AC outlet. Note: When the player is in the �STANDBY� mode, it is still consuming some power. If you wish to disconnect your player completely from the power, press POWER ON/OFF Caution: Only qualified service personnel should remove the cover or attempt to service this device.
Remote control battery installation
Loading the batteries
1 Open the battery compartment cover. 2 Insert batteries as indicated inside the battery compartment. 3 Close the cover.
Caution: Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the video signal of your TV.This setting only affects the television�s on-screen display that shows the stop and setup modes.You may select either NTSC or PAL.To change the DVD player setting to PAL or NTSC, follow the steps below.
1 Press the POWER ON/OFF button on the front panel of the DVD 2 3 4
player to turn OFF the DVD player. Press and hold / and T on the front of the DVD player.While holding / and T, press POWER ON/OFF. After PAL or NTSC appears on the display panel of the DVD player, release / and T at the same time.The PAL or NTSC that appears on the display panel indicates the current setting. To change the setting, press T within three seconds.The new setting (PAL or NTSC) will appear on the display panel.