Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
Text excerpt from page 16 (click to view)
Connecting the power cord
+ +
1 Plug the female end of the supplied power cord into the Mains (AC) jack 2
on the rear of the player. Connect the other end of the cord to an AC outlet. Note: When the player is in the �STANDBY� mode, it is still consuming some power. If you wish to disconnect your player completely from the power, press POWER ON/OFF Caution: Only qualified service personnel should remove the cover or attempt to service this device.
Remote control battery installation
Loading the batteries
1 Open the battery compartment cover. 2 Insert batteries as indicated inside the battery compartment. 3 Close the cover.
Caution: Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the video signal of your TV.This setting only affects the television�s on-screen display that shows the stop and setup modes.You may select either NTSC or PAL.To change the DVD player setting to PAL or NTSC, follow the steps below.
1 Press the POWER ON/OFF button on the front panel of the DVD 2 3 4
player to turn OFF the DVD player. Press and hold / and T on the front of the DVD player.While holding / and T, press POWER ON/OFF. After PAL or NTSC appears on the display panel of the DVD player, release / and T at the same time.The PAL or NTSC that appears on the display panel indicates the current setting. To change the setting, press T within three seconds.The new setting (PAL or NTSC) will appear on the display panel.