|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Straightforward ordering process. Service manual scan was clear & easy to read. Very comprehensive instructions for alignment. Excellent, thank you.
;
Fast, clear and useful. Important for me: the manual is in German.
;
Very good quality. Some parts are not fully readable, but the fundamental ones are fine.
;
very good quality readable manual,printed off very well.
;
The manual was very accurate for the part that I was changing, I was able to order the correct part and had no issues with the replacement procedure. However, I was expecting to have more detailed repairs for the lower drive unit.
DVD622MKII
3139 785 31162
EN 29
Firmware Upgrading
1 Burning of �rmware
1. Start the CD burning software and create a new CD Project (Data disc) with the following settings: a. File System: No Speci�c Requirement b. Format: MODE 2/XA c. Recording format: Single Session (Track at once), Finalized CD 2. Place the �le UPDATE VER and build.img into the root directory of the new CD project. 3. Burn the data onto a blank CDR or CDRW.
2
Firmware Upgrading
Burning of Firmware � After burned the �les to a CD-R or CD-RW,open the DVD tray and load the disc. � The DVD will read the disc and Display �Firmware Upgrade� with 2 options �Start� and �Cancel�. � Using the OK button on the remote control ,click on �Start� � The OSD will show �Firmware Upgrade� �Erase and Program� �Do not Power Off�. � Observe the DVD display �CD UPDT� and the DVD Tray door will open in less than 1 minutes, � The DVD tray closes and put the DVD player on standby.* *Note: At this time,key pressed on the remote control will have no effect on the set.
3
How to read the present �rmware version
� � � Open the DVD tray Press Display on Remote control. It will show �Cheetah170VX.XX DVD622/YYMKII I64R R1� where X is the Version number of the DVD Firmware and Y is the Stroke version of the DVD Player.
|
|
|
> |
|