I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Text excerpt from page 47 (click to view)
USING THE REMOTE'S VCR BUTTONS
W
hen using the TV remote with a VCR, first make certain it is set to control your VCR ( by the REMOTE CODE or SEARCH method - see earlier sections).
BEGIN
1 2
Press the VCR System button on the remote. Point the top of the remote
AV
POWER
Power Button
Press to turn the VCR ON and OFF.
GUIDE INFO
toward the front of the VCR (remote sensor window) when pressing buttons.
TV VCR PIP CH DN UP AUTO ACC SOURCE FREEZE
VCR System Button
Press to send remote commands to the VCR.
SWAP
STOP
Channel Scan Buttons
Press to scan up or down through VCR channel numbers.
TV-VCR (AV) Button
Press to the VCR position ("VCR" indicator on the VCR will light) to view the playback of a tape. Press again to place in the TV position ("VCR" indicator on the VCR will go OFF) to view one program while recording another program. When used with the television the AV button works as a source button. Each press cycles the TV between the AUX(iliary) Input modes, ANT A/B inputs, and the the last view channel. It is a quick one-button way to select these channels and modes (without directly entering the TV's Menu system.)
SLEEP
Number Buttons
STATUS/ EXIT MENU/ SELECT
Press buttons for direct VCR channel selections.
Play Button
VOL
MUTE
CH
Press to playback a tape. Hold down after pressing the RECORD button to start a recording.
Pause Button
1 4 7
100+
2 5 8 0
VCR PLUS+
3 6
Press to temporarily stop the tape during a playback, or recording. Press again to release Pause.
Stop Button
9
SURF
Press to stop the tape.
Status/Exit Button
Press to clear the screen of menu controls or display a feature operation status screen.
Fast Forward Button
REC RESET
Press to rapidly advance the tape. For some VCRs you may need to press STOP first then FF. In Playback mode hold button down to view the picture moving rapidly in the forward direction.
Record/VCR Plus+ Button
Press the RECORD button to start a recording (with some VCR models you may also need to press the PLAY button on the remote to begin recording). Also use this button to set timer recordings with the VCR Plus+ programming system.
CLEAR
SMART HELP
Remember, the VCR buttons on the remote will not operate your VCR if those features are not already found on your VCR remote control. Note: All VCR functions (particularly Search, Rewind, Fast Forward, etc.) will operate the same as with the original VCR remote control provided with the VCR.
47
Clear Button
Press to erase incorrect entries or data when programming VCR functions.
Open the remote control VCR button compartment with the pull tabs located on both sides of the hinged door or lid.
Rewind Button
Press to rewind tapes. For some VCRs you may need to press STOP button first then REWIND. In playback mode, hold button down to view picture moving rapidly in reverse.
