|
|
|
Who's Online
There currently are 5906 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Using the Remote Control
POWER
USING THE CODE-ENTRY METHOD TO PROGRAM YOUR TV REMOTE
TV SWAP DN SOUND
VCR PIP CH UP
ACC ACTIVE CONTROL FREEZE
PICTURE
N
ow that you have looked up the fourdigit remote-control Direct-entry Code for your brand of accessory device, you are ready to follow the simple steps shown below to program your TV remote. Please read through all the steps before beginning.
Satellite Receiver
Cable Converter Box
1
First, press and hold down the VCR or ACC (for an accessory device other than a VCR) mode button on the TV remote. Then press and hold down the MENU/SELECT button at the same time for a brief moment. Release the buttons. The TV remote back light will switch on. NOTE: For correct operation, you must first press and hold the mode button and then press and hold the MENU/SELECT button simultaneously. Within 30 seconds of pressing the VCR (or ACC) button and MENU/SELECT button, enter a four-digit code for the accessory device (see pages 21 and 22). If you make a mistake while attempting to enter the four-digit code and want to start again, press any button other than one with a number. Then return to step 1 to begin again.
DVD Player
VCR
2
POWER
1 3
TV SWAP DN SOUND VCR PIP CH UP PICTURE ACTIVE CONTROL FREEZE ACC
3
Point the remote at the accessory device. Then press the POWER button on the remote to turn the device on.
1
STATUS/ EXIT
MENU/ SELECT
HELPFUL HINTS
� If you do not enter a complete code within 30 seconds, you will need to perform step 1 of the Code-entry Method again. � If you enter more than four digits, the unit will retain the first four digits entered. � If the procedure explained above does not work the first time, repeat the steps using the same remote code number. � If after a second try the remote does not operate your accessory device, and more code numbers are listed for your brand, use the next listed code number. � If after repeated attempts the Entry-code Method does not allow you to work your accessory device with your TV remote, try the Search Method explained on the next page.
19
2
VOL
MUTE
CH
1 4 7
TV/VCR A/CH
2 5 8 0
POSITION PIP
3 6 9
SURF
|
|
|
> |
|
