|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
EN 60
8.
L01.1A AC
Alignments
A2T (TV A2 Threshold) Default value is 250. To adjust A2T: 1. To enter SDAM, press the following key sequence on the remote control transmitter: 0 6 2 5 9 6 directly followed by the MENU button (do not allow the display to time out between entries while keying the sequence). 2. Use the MENU UP/DOWN keys to highlight the AUDIO sub menu. 3. Press the MENU LEFT/RIGHT keys to enter the AUDIO sub menu. 4. Use the MENU UP/DOWN keys to select A2T. 5. Use the MENU LEFT/RIGHT keys to adjust the value of A2T to 250. 6. Press the MENU button to return to the top level SDAM menu. 7. To ensure the A2T setting is saved: � Turn the television set 'off' by using the 'POWER' button on the remote control transmitter or the local keyboard. Disconnect the television set from AC power for at least ten seconds. Reconnect the television set to AC power. Turn the television set 'on' by using the 'POWER' button on the remote control transmitter or the local keyboard
Parameter
20RF, 21RF, 25RF, 27RF, 29RF, 25", 28", 29"SF, 32V, 33"
25V 9 27V/29" 9
VX Vertical Zoom H60 Horizontal (NTSC) Shift Offset
25 9
25 25 25 25 25 35V 9 28WS 9 9 32WS 9 9
V60 Vertical Shift Offset (NTSC) 8.3.5 Audio
-2
-2 -2 -2 -2 -2 -2 -2 32WSRF
28WSRF
� � �
S
AF-M
XX
A2T
XX
CL 26532046_008.eps 040402
Figure 8-8 Audio alignment menu No alignments are necessary for the AUDIO sub menu. Use the default values. AF-M (NICAM threshold) Default value is 300. To adjust AF-M: 1. To enter SDAM, press the following key sequence on the remote control transmitter: 0 6 2 5 9 6 directly followed by the MENU button (do not allow the display to time out between entries while keying the sequence). 2. Use the MENU UP/DOWN keys to highlight the AUDIO sub menu. 3. Press the MENU LEFT/RIGHT keys to enter the AUDIO sub menu. 4. Use the MENU UP/DOWN keys to select AF-M. 5. Use the MENU LEFT/RIGHT keys to adjust the value of AF-M to 300. 6. Press the MENU button to return to the top level SDAM menu. 7. To ensure the AF-M setting is saved: � Turn the television set 'off' by using the 'POWER' button on the remote control transmitter or the local keyboard. � Disconnect the television set from AC power for at least ten seconds. � Reconnect the television set to AC power. � Turn the television set 'on' by using the 'POWER' button on the remote control transmitter or the local keyboard.
|
|
|
> |
|